-
Making an accurate cross cut sled for your table saw
A cross cut sled is probably one of the most important jigs in your workshop. Many woodworkers most commonly use a carpenter’s square to set the angle for their…
4 min read
-
Digital Angle Gauge Tips
The Digital Angle Gauge is not just for the table saw. If you have not been using it all over the shop then you might be missing out.…
4 min read
-
President’s Message May 2019
Summer is coming up and we cannot meet at Reel Lumber in June and August. We are looking for alternate locations for those meetings. We were looking at…
4 min read
-
Mini Router Table
How many times do you need to just round off the sharp edge of your project pieces. One simple tip is to set up an inexpensive trim router as…
4 min read
-
Freud Representative
Joe Mattias from Freud Tools will be here to talk about and answer questions on their entire line of saw blades and router bits. Please join us on…
4 min read